Common complements to finalize the integration of your Centilog modules. Nothing proprietary — these are off-the-shelf parts you can source anywhere. The enclosure is 3D-printable.
PLA model holding a Centilog module + ESP32 + LiPo battery, M3 screws, wall or stand mount. The print file is part of the project resources.
U.FL connector, short cable. Extends line-of-sight range. Must be calibrated after install (see the warning below).
Assorted M-M, M-F, F-F in 20 cm for breadboard prototyping. Available from any electronics reseller.
JST-PH 2-pin connector, charge/discharge protection. Powers a mobile tag for a few hours. Choose capacity to match your target runtime.
CALIB <dist> with a known reference distance).
These accessories are common off-the-shelf parts. To support the development of the Centilog open-hardware project:
Contribute via PayPal